Operating instructions

Targa 220V Instructions by Draper
Wiring Diagrams—220V Motor and Quiet Motor
Case Dimensions/Installation Diagrams
Page 2 of 3
Wall Mounted
Appropriate hardware
provided by installer.
Suspended
Appropriate hardware
provided by installer.
Fabric width + 192mm
Viewing
surface
96mm
22mm dia.
electrical
connection
hole
150mm
59mm
134mm
54 mm
67
mm
102 mm
162 mm
1.6
mm
203
mm
7
/8" hole for
electrical
connection.
Fasteners for
wall mounting
by others.
S Hooks for
suspended
installation
by others.
Optional Ceiling Opening Trim Kit
(Dims-Side View)
Methods of Installation
www.draperinc.com
(765) 987-799
9
Crimp
both
ends
Please Note: Do not wire motors in parallel.
Neutral
L1
220v,
50 Hz.
Dashed wiring
by installer
Control
switch
Single Station Control
CE Approved
Junction box at
left end of screen
Internal Screen Wiring
Blue-220v (Common)
Brown-220v (Down)
Black-220v (Up)
Dashed wiring
by installer
Neutral
Hot
Multiple Station Control
Not CE Approved
Cap off with wire
nut & tape
Red
Red
Red
Blue
Blue
Blue
Black
Black
220v, 50 Hz.
Black
Junction box at
left end of screen
Internal Screen Wiring
Blue-220v (Common)
Brown-220v (Down)
Black-220v (Up)
Green/Yellow (Motor Ground)
Green/Yellow (Motor Ground
)
ILT Limit Adjustment Continued from Page 1
➃ Set the slide switch to the higher position. Move the viewing surface to the desired
upper limit by pressing and holding the UP button on the wall switch.
➄ Return the slide switch to the center position to return to normal operation.
➅ To set the viewing surface to an alternate format position, move the viewing surface
to the desired position and press the STOP button.
Press and hold STOP for at
least three seconds to record
the position.
Please Note: Pressing and
releasing the UP button on the
switch will move the screen to its
upper limit. Pressing and releasing the DOWN button
will move the screen to its lower limit.
While the motor is in motion, pressing STOP for
less than two seconds will stop the viewing surface
at its present position.
Once the motor is stopped, pressing the STOP
button will move the viewing surface to its alternate format position.
Pressing and holding the STOP button, when the motor is at rest or in motion, for at
least three seconds will record a new alternate format position.
Wiring Diagrams—220V Motor and Quiet Motor
with Built-in Low Voltage Controller
Single Low Voltage Control
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Dashed wiring
by electrician
To 220V Line
Multiple Low Voltage Controls
Internal Screen Wiring
White (Neutral)
Black
Green (Ground)
Dashed wiring
by electrician
To 220V Line
Wall Switch,
RF or IR
Receiver,
or integrated
control system
Wall Switches,
RF or IR
Receivers,
or integrated
control systems
Data Cable
Data
Cables
S
S
T
T
O
O
P
P
To Motor
with
Built-In
Low Voltage
Slide
Switch
Back View
U
p
D
o
w
n
C
o
m
m
o
n
+
5V
DC
To Motor
with
Built-In
Low Voltage
POSITION
FUNCTION
DOWN
UP
CENTER
Set LOWER limit
Set UPPER limit
Normal Operation
STOP