Specifications

www.tvcinc.com
Section 1: Headend Equipment
Antennas
[phone]
1 - 5
CA Series Mount VHF Array
The SITCO CATV Series antenna arrays are designed for the cable system “head-end” sites. This series fills the
need for high gain deep fringe antenna arrays.
The SITCO CA-Series arrays are specifically tuned and cut to the individual channel (one channel only). With high
gain and sharp forward pattern, these arrays will insure excellent picture quality, due to the reduction in multipath
signal “pick-up”.
The antennas shown below are equipped with a balun transformer and a 75 ohm “F” connector termination.
Standard models include clamps for masts as large as 1-1/2" OD. Clamps for larger masts should be specified.
Ordering Information
• CA8-1-X ..................................Channels 2 through 6 & FM
• CA12-1-X ................................Channels 7 through 13
X = Specify channel #
CA Series Mount VHF Quad Array
The SITCO CATV Series multi-bay quad mounted antenna arrays are the ultimate in high performance and
durability for the CATV system “head-ends”.
These arrays are designed for high gain, high front to back ratio, extremely sharp forward “pick-up” lobe and large
aperture to weak signals.
Ordering Information
• CA32-4-X ................................Channels 2 through 6 & FM
• CA48-4-X ................................Channels 7 through 13
X = Specify channel #
Forward gain 14.0 db
Front-to-back ratio 22 db
Front-to-side ratio 17 db
Horizontal angle 32°
Forward gain 15.0 db
Front-to-back ratio 28 db
Front-to-side ratio 17.5 db
Horizontal angle 27°
CA8-1
Channels 2 through 6 & FM
CA12-1
Channels 7 through 13
Forward gain 20.0 db
Front-to-back ratio 39 db
Front-to side ratio 21.7 db
Horizontal angle 22°
Forward gain 20.0 db
Front-to-back ratio 41 db
Front-to-side ratio 19 db
Horizontal angle 20°
CA32-4 CVHF LO-BAND
Channels 2 through 6 & FM
CA48-4 VHF HI-BAND
Channels 7 through 13