SDS

8. Exposure Controls/Personal Protection
Occupational exposure limits
Canada. Alberta OELs (Occupational Health & Safety Code, Schedule 1, Table 2)
ValueComponents Type
TWA 1.4 mg/m3Hydrogen peroxide (CAS
7722-84-1)
1 ppm
Canada. British Columbia OELs. (Occupational Exposure Limits for Chemical Substances, Occupational Health and
Safety Regulation 296/97, as amended)
ValueComponents Type
TWA 1 ppmHydrogen peroxide (CAS
7722-84-1)
Canada. Manitoba OELs (Reg. 217/2006, The Workplace Safety And Health Act)
ValueComponents Type
TWA 1 ppmHydrogen peroxide (CAS
7722-84-1)
Canada. Ontario OELs. (Control of Exposure to Biological or Chemical Agents)
ValueComponents
Form
Type
TWA 155 mg/m3 Vapor and aerosol.1,2-Propanediol (CAS
57-55-6)
10 mg/m3 Aerosol.
50 ppm Vapor and aerosol.
TWA 1 ppmHydrogen peroxide (CAS
7722-84-1)
Canada. Quebec OELs. (Ministry of Labor - Regulation Respecting the Quality of the Work Environment)
ValueComponents Type
TWA 1.4 mg/m3Hydrogen peroxide (CAS
7722-84-1)
1 ppm
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
ValueComponents Type
PEL 1.4 mg/m3Hydrogen peroxide (CAS
7722-84-1)
1 ppm
US. ACGIH Threshold Limit Values
ValueComponents Type
TWA 1 ppmHydrogen peroxide (CAS
7722-84-1)
US. NIOSH: Pocket Guide to Chemical Hazards
ValueComponents Type
TWA 1.4 mg/m3Hydrogen peroxide (CAS
7722-84-1)
1 ppm
US. AIHA Workplace Environmental Exposure Level (WEEL) Guides
ValueComponents
Form
Type
TWA 10 mg/m3 Aerosol.1,2-Propanediol (CAS
57-55-6)
No biological exposure limits noted for the ingredient(s).
Biological limit values
Chemicals listed in section 3 that are not listed here do not have established limit values for
ACGIH or OSHA PEL.
Exposure guidelines
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level.
Appropriate engineering
controls
Individual protection measures, such as personal protective equipment
Wear safety glasses with side shields.
Eye/face protection
Skin protection
Rubber gloves. Confirm with a reputable supplier first.
Hand protection
#22823 Issue date 07-August-2018
Page: 3 of 9