B6 Drag Pak Instructions

ManualsBrandsDragRace Concepts ManualsCars & TrucksB6 Drag Pak No Prep Drag Racing Conversion Kit

Table Of Contents

Step #3

Step #2

Step #1

Install front shock tower to front bulkhead assembly

• (4) 3*6 Button Head Screws

Install front camber link mounts to front shock tower

• (1) 3*6 Button Head Screw Per Side

Install upper front bulkhead to lower front bulkhead

• (2) 3*8 Button Head Screws.

Install front bumper on the bottom of the front a-arm mount

• (3) 3*6 Button Head Screws

B6 Drag Pak / Works Edition.

Summary of content (6 pages)

PAGE 1
B6 Drag Pak / Works Edition. Step #1 Install upper front bulkhead to lower front bulkhead • (2) 3*8 Button Head Screws.
PAGE 2
B6 Drag Pak / Works Edition Step #4 Install clip style body mounts on bumper. Body posts can be trimmed to desired height. • (2) 4-40 x 1/4 Button Head Screws. Step #5 Install factory front a-arms onto front bulkhead Install (2) spacers between the front a-arms and the backside of the front bulkhead. Install front hinge pin support. • (2) 3*6 button head screws • (2) 2.5*3 button head screws Step #6 Install front end support plate onto front bulkhead.
PAGE 3
B6 Drag Pak / Works Edition Step #7 Bell Crank Installation. Install Team Associated factory bearings and spacers plate into included aluminum bell cranks. Install bell cranks onto bell crank mount. • (2) 3*16 button head screws. Step #8 Install 6 chassis stand offs. • (6) 3*6 countersunk screws Step #9 Install 4 rear chassis support stand offs.
PAGE 4
B6 Drag Pak / Works Edition Step #10 Install transmission support plate onto rear chassis support plate. • (2) 3*8 button head screws Step #11 Install top plates and transmission support plate assembly. • (4) 3*6 button head screws • (2) 3*8 button head screws Step #12 Install ESC mounting plate.
PAGE 5
B6 Drag Pak / Works Edition Step #13 Install front end assembly onto chassis. • (2) 3*6 countersunk screws • (2) 3*16 countersunk screws Step #14 - Works Edition Only Install rear shock tower using factory Team Associated Hardware. Step #15 - Works Edition Only Install rear body mount bracket, body mount plate and rear body mounts. • (2) 3*8 button head screws • (2) 3*6 countersunk screws Body Mounts.
PAGE 6
B6 Drag Pak / Works Edition Step #16 - Works Edition Only Install wheelie bar adapter. • (2) 3*16 button head screws Step #17 - Works Edition Only Install wheelie bar mount onto wheelie bar adapter. When installing the wheelie bar mount install the 3*30 button head screw first. Next install the upper 3*12 button head screw. Step #18 - Works Edition Only Install rear end assembly onto chassis using the factory Team Associated hardware.