DR10 ARB Instructions

Step #6
Step #5
Step #4
Install (2) 3mm ball studs into the anti roll bar arms.
Assemble anti roll bar tie rods and eyelets. The
overall length of the tie rod will be determined by your
ride height and suspension settings. Keep the
turnbuckle assembly as short as possible for
maximum performance.
Install the factory 3*20mm countersunk screws
through (2) 3mm cone washers and into the
rear body mount support.
Install anti roll bar assembly onto DR10
bulkhead using the factory shock tower
mounting hardware.
Connect lower eyelets to the molded ball
studs on the DR10 rear a-arms.
Check for a free moving assembly.
DR10 Anti Roll Bar Assembly