DR10 ARB Instructions

Table Of Contents

Step #3

Step #2

Step #1

Install (4) 3*10 and (2) 3*8 button head screws

through the rear shock tower and into the shock tower

mounts / anti roll bar mounts.

Install (2) 1/8 x 1/4 x 7/64 flanged bearings into

the anti roll bar mounts.

Install the Anti Roll Bar Shaft, Spacers and

Arms.

Use blue lock-tight on the (2) 4*3mm set

screws that attach the anti roll bar arms.

DR10 Anti Roll Bar Assembly

PAGE 1
DR10 Anti Roll Bar Assembly Step #1 Install (4) 3*10 and (2) 3*8 button head screws through the rear shock tower and into the shock tower mounts / anti roll bar mounts. Step #2 Install (2) 1/8 x 1/4 x 7/64 flanged bearings into the anti roll bar mounts. Step #3 Install the Anti Roll Bar Shaft, Spacers and Arms. Use blue lock-tight on the (2) 4*3mm set screws that attach the anti roll bar arms.
PAGE 2
DR10 Anti Roll Bar Assembly Step #4 Install (2) 3mm ball studs into the anti roll bar arms. Assemble anti roll bar tie rods and eyelets. The overall length of the tie rod will be determined by your ride height and suspension settings. Keep the turnbuckle assembly as short as possible for maximum performance. Step #5 Install the factory 3*20mm countersunk screws through (2) 3mm cone washers and into the rear body mount support.