Launch Assist Wheelie Bar Directions

Table Of Contents

Step #6

Step #5

Step #4

Launch Assist Wheelie Bar

Install (2) 1/8 x 5/16 x 7/64 bearings into

wheelie bar wheel.

Install wheelie bar wheel onto axle and secure

with e-clip.

Repeat for second assembly.

Install (1) 1/8 x 5/16 x 9/64 flanged bearing into outside

of the adjuster block.

Repeat for second assembly.

Install (1) O-Ring,(1) Washer) into the backside of the

adjuster block.

Install (1) e-clip onto pin and insert through the washer

and o-ring.

Repeat for second assembly.