User's Manual

Ethernet configuration
30
5.3 VLAN management
Go to Configuration > Ethernet > VLAN > VLAN page to set the VLAN Configuration.
FIGURE 25. VLAN configuration
To create a VLAN, select Create in the Action drop-down list and fill out all the parameters and click
Submit.
Similarly, a VLAN can be modified or deleted by selecting Modify or Delete in the Action drop-down
list and click Submit.
5.4 QoS scheduler
Go to Configuration > Ethernet > QoS > QoS page to set the QoS Scheduler. Three scheduling
modes are supported:
• Strict Priority
• Weighted Round Robin (WRR)/Deficit Weighted Round Robin (DWRR)
• Strict Priority + WRR/DWRR
While the Strict Priority Queue Number is 8, it is SP mode. While the number is less than 8, it is SP
+ WRR or SP + DWRR two scheduler modes.
The default scheduling mode is SP+WRR, 4 SP queue + 4 WRR queue, the weight for Q4-Q1 are
8:4:2:1. The Wireless Port Rate Limit will only take effect when its value is lower than the Wireless
Throughput.
Speed and Duplex Under the autoneg disabled status, speed and duplex of port can be
configured, only 100Base-THD, 100Base-TFD and 1000Base-TFD
can be supported.
Speed and Duplex Status It displays the current status of Ethernet speed and duplex.
TABLE 15. VLAN configuration
Parameter Description
VLAN ID The VLAN 1 is a special VLAN used to forward untagged traffic and for
local management, it is a permanent VLAN and cannot be deleted. It
includes Eth1 and Wireless port by default.
The available values of VLAN ID are 51 ~ 4094, 2 ~50 are reserved by
system. They are all tagged VLAN. The maximum number of VLANs is
48.
TABLE 14. Ethernet port speed configuration
Parameter Description
draft