User's Manual

23
System configuration
3.8 SNTP
Steps
1. Go to Configuration > System > SNTP page.
FIGURE 17. SNTP
2. To set SNTP, fill out all the parameters and click Submit.
3.9 Synchronization
Steps
1. Go to Configuration > System > Synchronization page.
FIGURE 18. Synchronization
2. To set Synchronization, fill out all the parameters and click Submit.
TABLE10. SNTP
Parameter Description
Time Server IP It is used to get SNTP time from Time Server.
Time Zone Offset Configure the NE time zone when Time Server is configured.
Values are from -12 ~ +13.
Daylight Saving Configure the NE daylight saving when Time Server is configured. Value is
Enabled or Disabled.
draft