User's Manual

Commissioning
16
FIGURE 8. Step 3
4. In Configuration Summary page, set the Setup Frequency field according to Table 9.
TABLE 7. Wireless parameters
Parameter Description
Link Name Up to 32 characters, and both numbers and characters are supported. The link
name of both Control Site and Passive Site should be the same.
System Role Control Site or Passive Site.
One end of Lite should be configured as the Control Site, and the other end the
Passive Site.
Antenna Stream V+H Stream supported.
Bandwidth 40 MHz or 20MHz.
Traffic Mode (Uplink/
Downlink)
50/50
For 50/50, the uplink and downlink have the same bandwidth.
Guard Interval 400 ns or 800 ns.
If the maximum multi-path delay spreads more than 400 ns, we suggest to use
800 ns. Leaving the guard interval at 400 ns (the default) works in most applica-
tions. For installations where the link is over long stretches of water, or non-line of
sight applications with lots of multi-path signals, selecting 800 ns guard interval
can improve the performance.
Wireless Port Rate
Limit
Rate limit on Wireless port. It will only take effect while the value is lower than the
Wireless Throughput.
Static Modulation If ACM is disabled, Lite will use Static Modulation as Tx side modulation. This is
the modulation selected for this link and will not change unless ACM is enabled.
Tx Power Tx power on each radio. Limited by EIRP. This rate limit is automatically assigned
based on the modulation selected.
draft