User's Manual

Commissioning
14
FIGURE 5. Management VLAN
2.2.4 Setting the radio parameters
This operation should be done from both the passive and control ends of the link and channel selec-
tions should match to ensure the link comes up when properly aligned. Before setting the radio
parameters, ensure that the correct radio standard is licensed for the geographic location where the
radio is to be installed. For example: FCC for USA or Canada, ETSI for Europe and Asia, etc.
It is also important to verify that the correct maximum speed required is licensed, as per the link
design specified for the radio in this location.
Steps
1. Go to Setup > Commissioning tab (see Figure 6) and click Next Step.
FIGURE 6. Step 1
2. Input the license key and click Modify. Click Refresh to make sure of the configuration.
TABLE 6. Management VLAN
Parameter Description
Management
VLAN
Configure the management VLAN ID for remote login. VLAN range from 51 ~ 4094.
Default: 127.
Management
VLAN Priority
Configure the management VLAN priority. Value from 0 ~ 7. Default: 6.
Eth1 If the port is to be used as a part of the management VLAN, set to Yes. If no, it means
this port is removed from the management VLAN.
Eth2
Ath1(wireless1)
Rate Limit Configure the engress and eggress rate limit for management VLAN. Value from
128Kbps ~ 2Mbps. Default: 1024Kbps.
draft