Installation Guide

Table Of Contents

Cabling

3. (Optional) Unplug another waterproof plug and connect the Ethernet cable from P+E OUT

(ETH 2) interface to a LITE for cascading through the cabling channel.

4. Close the doghouse.

4.1.2 PoE+ connection

FIGURE 17. PoE+ connection

Steps:

1. Unscrew the doghouse cover and open it.

2. Connect the INTERNAL interface and P+E IN (ETH 1) interface with a short Ethernet cable.

3. Unplug one of the waterproof plugs and connect the Ethernet cable from POE+ IN interface

to an IDU outside through the cabling channel or to a LITE to which it is cascaded.

4. (Optional) Unplug another waterproof plug and connect the Ethernet cable from P+E OUT

(ETH 2) interface to a LITE for cascading through the cabling channel.

5. Close the doghouse.

4.2 External antenna connection

When external antenna is used, the following picture shows the connection of the antenna cables.

Doghouse Cover

P+E OUT (ETH 2)

POE+ IN

INTERNAL

P+E IN (ETH 1)

Internal Connection

For Cascading

To IDU or to LITE (when cascaded)

Cabling Channels

Waterproof Plugs