User's Manual

Commissioning
8
LITE, R1.0, Operation and Maintenance Guide, Issue 1
FIGURE 5.
Management VLAN
2.2.4 Setting the radio parameters
Before setting the radio parameters, ensure that the correct radio standard is licensed for the geo-
graphic location where the radio is to be installed. For example: FCC for USA or Canada, ETSI for
Europe and Asia, etc.
It is also important to verify that the correct maximum speed required is licensed, as per the link
design specified for the radio in this location.
Steps
1.
Go to Setup > Commissioning tab (see Figure 6) and click Next Step.
FIGURE 6.
Step 1
2.
Input the license key and click Modify. Click Refresh to make sure of the configuration.
TABLE 5. Management VLAN
Parameter Description
Management
VLAN
Configure the management VLAN ID for remote login. VLAN range from 51 ~ 4096.
Default: 127.
Management
VLAN Priority
Configure the management VLAN priority. Value from 0 ~ 7. Default: 6.
Eth1 If the port is to be used as a part of the management VLAN, set to Yes. If no, it means
this port is removed from the management VLAN. If the management VLAN setting has
been set to yes, it doesn’t need to be added into the VLAN table in Ethernet > VLAN >
VLAN page.
Eth2
Ath1(wireless1)
Rate Limit Configure the engress and eggress rate limit for management VLAN. Value from
128Kbps ~ 2Mbps. Default: 256Kbps.