User's Manual

Link Layer Discovery Protocol (LLDP)

Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4

ECFM CLI Command

Description

set ecfm cc enable level

Enables or disables the transmission of continuity check messages

(CCMs).The level ID and Vlan ID identifies the Maintenance End

Points (MEPs)to which the configuration applies if Vlan is not

specified, enables the transmission of CCMs at specified levels for

Vlan unaware MEPs only.

Sequence:

set ecfm cc enable level [disable] {levelid | level-list} [vlan

{vlanid | vlan-list}] press Enter

Where

level {<level-id(0-7) identifies the maintenance domain’s level.

Range is from 0 to 7.

level-list identifies a list of domain levels.

vlan {<vlan-id(1-4094)> specifics a Vlan ID.

vlan-list identifies a list of Vlan IDs.

The system responds:

< no response >

The system returns to the prompt ->.

set ecfm mip dynamic

evaluation

Enables or Disables the implicit evaluation and creation of a MIP.

Note:

This command is NOT supported in this HC ODU release.

set ecfm mip level

Configures a Maintenance intermediate point (MIP) at the specified

level and vlan on an interface.

active - makes MIP operationally active, by default MIP is configured

as operationally active.

Sequence:

set ecfm mip level [delete] <level-id(0-7)> vlan <vlan-id(1-

4094)> [active] press Enter