User's Manual

DragonWave Inc.
46
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
ECFM CLI Command
Description
set ecfm mep crosscheck
mpid
Statically defines maintenace end point (MEP) or remote MEP.
(MEP is defined in a list of MEPIDs of a service associated with a
provided VLAN)
Sequence:
set ecfm mep crosscheck mpid <integer(1-8191)> [delete|define]
[vlan <integer(1-4094)>] press Enter
Where
mpid <integer(1-8191)> identifies MEP identifier.
vlan <integer(1-4094)> specifics a Vlan ID
Examples:
To define a mep crosscheck / remote MEP
set ecfm mep crosscheck mpid 70 vlan 100 press Enter
To delete a mep crosscheck / remote MEP
set ecfm mep crosscheck mpid 70 delete vlan 100 press Enter
The system responds:
< no response >
The system returns to the prompt ->.
set ecfm mep level
Configures or deletes a local Maintenance end point (MEP) (Sets
an port as a domain boundary (edge)by defining it as a MEP), and
sets direction for the MEP.)
Sequence:
set ecfm mep level [<0-7>] [delete] [inward] [mpid <id(1-
8191)>] [vlan<vlan-id(1-4094)>] [active] press Enter
Where
level [<0-7>] identifies the maintenance domain’s level. Range is
from 0 to 7.
delete is to delete this local MEP.
inward specifies the direction. By default, “outward” is created, that
is “Down MEP”.
mpid <id(1-8191) is the MEP identifier.
vlan<vlan-id(1-4094) specifics a Vlan ID.
active specifies the MEP’s operational status. By default, MEP is not
active.
The system responds:
mep-:
mep-: means that current input status is in the mep-status.
This command is required before issuing one of the following
commands:
set ecfm mep-capability level
set ecfm ccm-unicast-mac