User's Manual

Link Layer Discovery Protocol (LLDP)
43
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
ECFM CLI Command
Description
set ecfm mip ccm-
database hold-time
Sets the hold time for the ecfm ccm-database, in hours.
The default is 24 hours.
Sequence:
set ecfm mip ccm-database holdtime [<hours>(24-48)] press
Enter
The system responds:
< no response >
The system returns to the prompt ->.
Example:
See the example in the command – set ecfm mip ccm-database
cacheing.
set ecfm domain
Defines or selects a connectivity fault management (CFM)
Maintenance Domain (MD) at a particular maintenance level, where
parameters specific to the maintenance domain can be set.
Sequence:
set ecfm domain <domain-name(1..20)> level <level-id(0-7)>
[delete] press Enter
Where
domain-name identifies the domain. Character string has a
maximum limit of twenty characters.
level identifies the maintenance domain’s level. Range is from 0 to 7.
Example:
set ecfm domain test_md_1 level 1 press Enter
The system responds:
domain-1:
->
Where
domain-n: n is the domain index, which corresponds to the
Index column entry in response to the get ecfm domain
command.
If there is no domain named test_md_1 and level is 1, the system
will create a domain with the parameters: test_md_1 and 1.
If a domain with this name already exists, but at a different level, the
system will respond with an error message.
If there is a domain that exists in the system with the same level, the
system will select this domain as the current setting domain.
It is necessary to use this command before calling the following
commands:
set ecfm mip-creation-criteria
set ecfm service
set mep crosscheck mpid
set ecfm mep archive-hold-time
Note:
Horizon Compact Plus release 1.2 only supports character string
type domain names.