User's Manual

Link Layer Discovery Protocol (LLDP)
35
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
4.3 ECFM CLI Commands List
ECFM CLI Command
Description
set ecfm
Enables or disables connectivity fault management (CFM)
processing globally on this device.
The default is "off".
Sequence:
set ecfm [on | off] press Enter
The system responds:
< no response >
The system returns to the prompt ->.
Example:
set ecfm on press Enter
To verify the setting, run the command – get ecfm global information
get ecfm global information press Enter
The system responds:
Configured OUI : 00:00:00
ecfm Status : Started, Enabled
…..
Where
Enabled means that ecfm is on
Disabled means that ecfm is off
set ecfm y1731
Enables(on) or disables(off) Y.1731 processing globally on a device.
For Y.1731 to be enabled, ecfm should be enabled. When Y.1731 is
off, ecfm default protocol is 802.1ag.
Sequence:
set ecfm y1731 [on | off] press Enter
The system responds:
< no response >
The system returns to the prompt ->.