User's Manual

Link Layer Discovery Protocol (LLDP)
23
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
Procedure 3-1
Configuring LLDP
Required
Action
Steps
login
Log in as a NOC user.
Enable the LLDP
module
This command enables/disables LLDP on the system
set lldp module [on/off] – Example :
Sequence:
set lldp module on press Enter
System responds
Start LLDP
This command starts LLDP on the system
set lldp system [start/stop] – Example:
Sequence:
set lldp system start press Enter
System responds
Configure port
This command configures dot1 TLV types on a port.
set lldp interface tlv-select dot1tlv {switchport <port-num>} {[port-vlan-id]
[protocol-vlan-id {all |<vlan-id>}] [vlan-name {all | <vlan-id>}]} {on | off}
Example:
Sequence:
set lldp interface tlv-select basic-tlv switchport 2 mgmt-addr all on press
Enter
System responds: