User's Manual

DragonWave Inc.
20
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
Required Action
Steps
clear port eoam config
Clears ethernet OAM local configuration for all ports/specific port.If the
port is not specified, it clears the configuration of both ports.
Sequence:
clear port eoam config [port <1-2>] press Enter
Example:
clear port eoam config press Enter
To verify the setting, run the command:
get port eoam fault-management config press Enter
The system responds: (Example)
-------------------------------------------------------------------
Frame Frame Frame secs Critical Dying Link MaxVar
Port Period Summary Event Gasp Fault Req
------- ------- ------- ---------- -------- ------- ------- ------
P1 warning warning warning warning warning warning 10
P2 warning warning warning warning warning warning 10
clear port eoam event-log
Clears EOAM event logs.If port num is not specified, it clears the event
logs of both ports.
Sequence:
clear port eoam event-log [port <1-2>] press Enter
Example:
clear port eoam event-log press Enter
To verify the setting, run the command:
get port eoam event-log press Enter
< no response >
The system only returns to the prompt ->.
clear port eoam fault-
management mib-variable
response
Clears MIB variable response received from the peer. If port num. is
not specified, it clears response on both ports.
Sequence:
clear port eoam fault-management mib-variable response [port
<1-2>] press Enter
Example:
clear port eoam fault-management mib-variable response press
Enter
To verify the setting, run the command:
get port eoam fault-management mib-variable response press
Enter
The system responds:
% Unable to get variable response table entry
Save changes to MIB
Saves the MIB to RAM. Perform this command to save setting changes
to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully