User's Manual

Ethernet Operation Administration and Maintenance (EOAM)
15
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
Required Action
Steps
set port eoam fault-
management mib-request
Send MIB variable request to peer.
Sequence:
set port eoam fault-management mib-request [port <1-2>]
<branchleaf:branchleaf:...> press Enter
Where
branch identifies variable branch derived from CMIP protocol
encodings in ANSI/IEEE Std 802.3 Annex 30A.
leaf identifies variable leaf derived from CMIP protocol encodings in
ANSI/IEEE Std 802.3 Annex 30A..
Example:
set port eoam fault-management mib-request port 1
7247:7333:7334 press Enter
< no response >
The system returns to the prompt ->.
To verify the setting, run the command:
get port eoam fault-management mib-variable response press
Enter
The system responds: (Example)
MIB variable responses received on interface P1
MIB Variable response: 1
----------------------
Branch Leaf Width/Indication Value
------ ---- ---------------- --------
07 00f7 04 01020000
07 014d 04 00000009
07 014e 01 0e
Where:
SNMP CMIP CMIP
Oid Branch Leaf Attribute
======================= ====== ==== =======================
1.3.6.1.2.1.158.1.2.1.3 7 247
aOARemoteVendorSpecificInfo
1.3.6.1.2.1.158.1.1.1.2 7 333 aOMDiscoveryState
1.3.6.1.2.1.158.1.1.1.6 7 334 aOAMLocalConfiguration
Note:
To support Eoam Mib Variable Request, system’s Eoam fault
management must be started and enabled.
get eoam global information
Displays ethernet OAM global information.
Sequence:
get eoam global information press Enter
Example:
get eoam global information press Enter
The system responds: (Example)
Ethernet OAM has been enabled
OUI configured is 00:07:58
Error event OAMPDU resend count:10