User's Manual

DragonWave Inc.
10
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
Required Action
Steps
set port eoam link-monitor
Enables or disables link events for EOAM monitoring.
Sequence:
set port eoam link-monitor [port <1-2>] [frame | frame-period |
frame-sec-summary] [ on | off] press Enter
Where
port identifies a port number.
Link monitor event type:
frame : Frame Event is generated, when the number of frame
errors exceeds a threshold within a given window defined by
a period of time. (e.g. 10 frames in 1 second had errors)
frame-period: Frame Period Event is generated, when the
number of frame errors exceeds a threshold within a given
window defined by a number of frames (e.g. 10 frames out of
10000 had errors).
frame-sec-summary: Frame–secs-summary Event is generated,
when the number of frame errors exceeds a threshold within
a given time period (e.g. 10 frames seconds within the last
100 seconds). An error frame second is defined as a 1
second interval which has frame errors > 0.
The system responds:
< no response >
The system returns to the prompt ->.
Example:
set port eoam link-monitor port 1 frame off press Enter
To verify the setting, run the command:
get port eoam event-notifications press Enter
The system responds: (Example)
Link Event Notifications
---------------------------------------------------
Frame Frame Frame secs Critical Dying
Port Period Summary Event Gasp
------- ------- ------- ---------- -------- -------
P1 disable enable enable enable enable
P2 enable enable enable enable enable
Note:
To support Eoam Link Monitor, system’s Eoam fault management
must be started and enabled.