User's Manual

DragonWave Inc.
8
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
Required Action
Steps
set port eoam remote-
loopback
Allows the user to enable or disable EOAM remote loopback, and to
deny or permit EOAM remote loopback feature request from its peer.
Sequence:
set port eoam remote-loopback [port <1-2>] [on | off | deny |
permit] press Enter
The system responds:
< no response >
The system returns to the prompt ->.
Example #1:
set port eoam remote-loopback port 1 permit press Enter
To verify the setting, run the command – get eoam local information
get eoam local information press Enter
The system responds: (Example)
Eoam Functions Supported by Local:
Port Remote Loopback Link Event UniDir Variable Retrieval
------- --------------- ---------- ------- ------------------
P1 permit enable disable enable
P2 deny enable disable enable
……
Example #2:
set port eoam remote-loopback port 1 on press Enter
To verify the setting, run the command – get eoam local information
get eoam local information press Enter
The system responds: (Example)
Eoam Local Information:
Port State Mode Status LinkMonitor ConfigRev MaxPdu
------- -------- ------- -------------- ----------- --------- ------
P1 enable active R-Loopback enable 0 1518
P2 disable active Disabled enable 0 1518
……
Note:
1. To support Eoam loopback, system’s Eoam fault management
must be started and enabled.
2. HC ODU only supports Eoam Loopback on port 1.
3. EOAM discovery process must be in operational state before
enabling EOAM remote loopback operation.
4. EOAM remote loopback must be set to ‘permit’ in order to
process the loopback command from the remote end.