User's Manual

Ethernet Operation Administration and Maintenance (EOAM)
7
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
Required Action
Steps
To verify the setting, run the command :
get port eoam local information press Enter
The system responds: (Example)
Eoam Local Information:
Port State Mode Status LinkMonitor ConfigRev MaxPdu
------- -------- ------- ------------- ----------- --------- ------
P1 enable active Operational enable 0 1518
……
set port eoam mode
Configure EOAM mode in a port.
The default is "active"
Sequence:
set port eoam mode [port <1-2>] [active | passive] press Enter
where
active: Eoam node with active mode initiates the exchange of the
information OAMPDUs for the discovery process to settle.
Active device should not respond to OAM remote loopback
commands and variable requests from a Passive peer.
passive: Eoam node with passive mode does not initiate the
discovery process. It reacts to the initiation of discovery
process by Remote peer.
Example:
set port eoam mode port 1 active press Enter
To verify the setting, run the command :
get port eoam local information press Enter
The system responds: (Example)
Eoam Local Information:
Port State Mode Status LinkMonitor ConfigRev MaxPdu
------- -------- ------- ------------- ----------- --------- ------
P1 enable active Operational enable 0 1518
……