User's Manual

DragonWave Inc.
6
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
Required Action
Steps
Change the current status of
the eoam AAM message
option.
Note that if HAAM is
enabled this command is
still valid
This command enables or disables the option to send out an eoam
message when AAM or HAAM up/down-switches modulation schemes.
Sequence:
set aam eoam option [on|off]
Example: set aam eoam option on press Enter
The system responds:
Eoam option for AAM is set to :on
View current status of the
eoam RLS message option.
Use this command to view the current status of the eoam message
option for RLS events.
Sequence:
get rls shutdown policy press Enter
The system responds:
RLS shutdown notification policy: eoam-msg
Change the current status of
the eoam RLS message
option.
This command enables or disables the option to send out an eoam
message when an RLS event is triggered.
Sequence:
set rls shutdown policy [port-down | eoam-msg]
Example: set rls shutdown policy port-down press Enter
The system responds:
RLS shutdown notification policy is set to :port-down
set eoam fault-management
Start, enables or disables the eoam fault-management on the system.
The default is "off".
Sequence:
set eoam fault-management [start | on | off] press Enter
The system responds:
< no response >
The system returns to the prompt ->.
Example:
set eoam fault-management start press Enter
set eoam fault-management on press Enter
To verify the setting, run the command :
get eoam fault-management global information press Enter
The system responds: (Example)
Fault-management module has been enabled
set port eoam
Enable or disable EOAM on a port.
The default is "off".
Sequence:
set port eoam port [port number] [on | off] press Enter
The system responds:
< no response >
The system returns to the prompt ->.
Example:
set port eoam port 1 on press Enter