User's Manual

Ethernet Operation Administration and Maintenance (EOAM)
5
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 4
Required Action
Steps
set eoam link-monitor event-
resend
Configure Error-Event Resend Count on this device.
The default is 10.
Sequence:
set eoam link-monitor event-resend [count(1-10)] press Enter
The system responds:
< no response >
The system returns to the prompt ->.
Example:
set eoam link-monitor event-resend 10 press Enter
To verify the setting, run the command – get eoam global information
get eoam global information press Enter
The system responds: (Example)
Ethernet OAM has been enabled
OUI configured is 1c:08:00
Error event OAMPDU resend count:10
View current DragonWave
eoam message mode
This command returns the current DragonWave eoam message mode.
EOAM protocol can be used or it can be bypassed.
Sequence:
get eoam dwi-msg mode press Enter
The system responds:
Eoam DWI specific msg mode: bypass-eoam
Change the DragonWave
eoam message mode
Use this command to change the current DragonWave eoam message
mode. Either “bypass-eoam” or “eoam” can be selected. Selecting
“bypass-eoam” sends the DragonWave eoam packets directly via the
Ethernet layer. Selecting “eoam” sends packets through the eoam
protocol layer.
sequence:
set eoam dwi-msg message mode [bypass-eoam|eoam]
Example: set eoam dwi-msg message mode eoam press Enter
The system responds:
Eoam DWI specific msg mode is set to :eoam
View current status of the
eoam AAM message option.
Note that if HAAM is
enabled this command is
still valid
Use this command to view the current status of the eoam message
option for AAM or HAAM changes.
Sequence:
get aam eoam option press Enter
The system responds:
Eoam option for AAM is: off