User's Manual

Installation Requirements

Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 1

Hole

Plugs

4.3.2 Outdoor PonE Unit Weatherproof Grommet Seals

The cable entry points into the outdoor PonE unit are protected from moisture ingress by special rubber

grommet seals. Each grommet has three holes to accommodate up to three cables (two CAT5 and one

power). Rubber plugs are provided for holes that are not being used. Two holes, for CAT5, have a split

side to allow pre-terminated cables to be easily inserted. The third hole, which is smaller, is not split but

allows un-terminated power cables to be pushed through. A gland nut is used to secure the cables and

create the seal. Ensure that the rubber plugs are in place for all holes not occupied by cables and that the

grommet sits squarely in its receptacle before tightening the gland nut to secure the seal.

Note that any pre-terminated

cables will need to have the

connectors staggered, as shown,

lower left, in Figure 4-9, in order

for them to pass through the hole

in the PonE unit housing

Figure 4-9 Weatherproof

Grommet Seals

4.3.3 Using Indoor PonE Unit

Figure 4-10 Indoor Unit PonE and RJ45 Connections