User's Manual

DragonWave Inc.
54
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
Required Action
Steps
Configure system speed
Sets the system speed. (Cannot exceed the speed key purchased with
your system).
Sequence:
set system current speed 50 press Enter
System responds:
System speed set to 50 Mbps
Note: For asymmetric speeds the speed at the other end of the link
would be set to a different value.
Example:
Near end – set system current speed 50 press Enter
Far end – set system current speed 100 press Enter
Note: if the speed at one end was to be the purchased speed (default),
then this command would not need to be invoked at that end.
Save changes to mib
Saves the MIB to RAM. Perform this command to save setting
changes to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
Reset system
A system reset is required to activate this feature.
Sequence
reset system press Enter
The system responds:
Are you sure you want to reset? Y(yes) or N(no)
press Y
The system will proceed to reset. You will have to log on again to
regain access.