User's Manual

DragonWave Inc.

Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2

5.3 Configuring SyncE

Procedure 5-1

Configuring syncE

All the commands in the following procedure are immediately invoked. There is no need to perform a

save mib or reset system to make the feature active.

Required Action

Steps

View current status of SyncE

This command returns the current status of the SyncE feature

Sequence:

get synce status press Enter

The system responds:

Synce mode is off

OR, if SyncE mode is active (example):

Synce mode :auto

Clock source :freerun

Acquisition status :acquired

Forced holdover :off

Add ports that are to be used

for SyncE to the member

group

This command allows you to add all the ports that are required to

handle SynchE into the member port group. Note that in order to

configure the ports that are to be the primary and secondary clock

sources, the ports must first be made part of the member port group.

Sequence:

set synce member port [p1|p2|p3|p4|wp1|freerun]

Example: set synce member port p4,wp1 press Enter (note the

comma)

The system responds:

synce members:p4,wp1,freerun

Note: valid synce member port includes p1,p2,p3,p4,wp1;

freerun is always a synce member.