User's Manual

Detailed CLI Command List
159
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
CLI Command
Description
set port eoam fault-management mib-
variable count [port <1-2>] <count(1-100)>
Sets the maximum MIB variables that can be sent in one
OAM variable request pdu.
set port eoam fault-management remote-
loopback [port <1-2>] [test] [count <no of
packets(1-1000)>] [packet <size(64-
1500)>] [pattern <hex_string(8)>] [wait-time
<integer(1-10)>]
Specify number of packets and packet size for EOAM
loopback test. This command also triggers the loop back
test.
set port eoam link-monitor [port <1-2>]
[frame | frame-period | frame-sec-
summary] [on | off]
Enabling or disabling link events for EOAM monitoring.
set port eoam link-monitor default [port <1-
2>] [frame | frame-period | frame-sec-
summary] [threshold | window]
Sets the link monitoring parameters threshold and window
to the default value.
set port eoam link-monitor frame-sec-
summary threshold [port <1-2>] [<count(0-
900)>]
Threshold error count for frame seconds summary should
be lesser than window size.
set port eoam link-monitor frame-sec-
summary window [port <1-2>] [<size(100 -
9000)>]
Specifying the window size for frame second
summary.Window size should be greater than threshold
count.
set port eoam link-monitor threshold [port
<1-2>] [frame |frame-period]
[<count(1234..)>]
Specifying the threshold error count for link monitoring
events.Threshold count should be lesser than window size
for frame-period.
set port eoam link-monitor window [port <1-
2>] [frame <size(10 - 600)> | frame-period
<size(1100000 - 89000000)> ]
Specifying the window size for link events for ethernet
OAM link monitoring. Frame-period window size should
be greater than threshold count.
set port eoam mode [port <1-2>] [active |
passive]
Specify eoam mode as active or passive.
set port eoam remote-loopback [port <1-2>]
[on | off | deny | permit]
Allows the user to enable or disable EOAM remote
loopback. and to deny or permit EOAM remote loopback
feature request from its neighbour.
set programmed frequency [IndexID]
sets the frequency of the TX IF and RF stage [Index ID] is
the index of frequency list specified in 'get available
frequency' command. Before using this command, first set
the available Frequency.
set qos [on/off]
enables or disables the dot1p qos. Setting 'on' enables the
dot1p qos.
set qos policy [strict priority / wfq]
sets the qos policy [strict prioirty or wfq].
set queue utilization threshold [qid] [depth]
[time]
sets the threshold for the Queue Depth trap
set radio band [radioBandName]
set the radio frequency band to be used in the system.
Radio bands supported by the system can be obtained
using'get radio band' command.
set radio config
Leads you through the steps to configure the radio