User's Manual

Detailed CLI Command List
155
Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
CLI Command
Description
set ecfm [on | off | start]
on / off : Enables or disables connectivity fault
management (CFM) processing globally on this device.
Start : Start the Ethernet CFM Module globally on the ODU.
set ecfm associate vlan-id {vlan-id | vlan-
list} primary-vlan-id <vlan-id(1-4094)>
Associate a list of Vlan-Ids to a Primary Vlan.
set ecfm cc enable level [disable] {levelid |
level-list} [vlan {vlanid | vlan-list}]
Enables or disables the transmission of continuity check
messages (CCMs).The level ID and Vlan ID identifies the
Maintenance End Points (MEPs)to which the configuration
applies.-Vlan if not specified, enables the transmission of
CCMs at specifiedlevels for Vlan unaware MEPs only.
set ecfm cc level {<level-id(0-7)> | level-list}
{<default [interval] [role]> | [vlan {<vlan-
id(1-4094)> | vlan-list}] [interval {ten-sec |
one-min | ten-min}]}
Sets parameter (CCM Interval) for continuity check
messages (CCMs).The level ID and Vlan ID identifies the
Service (Maintenance Association) to which the
configuration applies. - Vlan if not specified, sets (CCM)
interval at specified levels for Vlan unaware services
(Maintenance Association) only. - default resets to default
values. - default role resets only the role to default. - default
resets only the interval to the default.
set ecfm ccm-unicast-mac
<aa:aa:aa:aa:aa:aa>
Sets the destination mac-address for ECFM unicast
Continuity Check Messages. a unicast mac cannot start
with 00: or FF: .
set ecfm default-domain global levelid <(0-
7)>
Defines or deletes a connectivity fault management (CFM)
Maintenance Domain (MD) at a particular maintenance
level and puts the device in Ethernet CFM configuration
mode, where parameters specific to the maintenance
domain can be set.
set ecfm default-domain vlan <integer(1-
4094)> ([level<integer(0-7)>][mip-creation-
criteria {none | explicit | defer |
default}][sender-id-permission {none
|chassis | manage | chassis-mgt-address |
defer }])
Sets the parameters of default Maintenace Domain (MD)
Level, to control MHF creation at the VLAN Ids which are
not attached to any Service (Maintenance Association) and
SenderID TLV transmission by those MHFs.
set ecfm disassociate vlan-id {vlan-id |
vlan-list} primary-vlan-id <vlan-id(1-4094)>
Dis-Associate a list of Vlan-Ids to a Primary Vlan.
set ecfm domain <domain-name(1..20)>
level <level-id(0-7)> [delete]
Sets the global default Maintenance Domain (MD
)parameters to control MIP creation and SenderID TLV
transmission by MHFs.
set ecfm error-log [on | off] [size <entries(1-
4096)>]
Enables or disables the logging of Continuity Check errors
that occurred on the device in the Error Log table and also
sets the maximum size of the table.
set ecfm mep archive-hold-time {
<minutes(100-65535) | default }
Sets the amount of in minutes time such that information
from a MEP is kept in the CC database before they are
purged. Defaults sets to 100 minutes.