User's Manual

Horizon Compact Plus Release 1.0.1 Wireless Ethernet Product User Manual – Volume 2
18.0 Event and Performance Logging
The Horizon Compact Plus system supports two logs, the Events Log and the Performance Log. Each
can be used to track the behaviour of the system over time. In addition, a “Syslog” feature can be
invoked that sends information stored in the event and performance logs to a remote syslog server, for
further analysis.
18.1 Events Log
The Events Log is invoked or disabled by issuing the CLI command set logging [on/off]. This log
records alarm and reset events. Approximately 17,500 events can be captured by the Events log. Once
the log is full the oldest entries are overwritten. See Procedure 18-1 for more details.
Procedure 18-1
Events Log
Required Action
Steps
login
Log in as a NOC account
View events log status
This command returns the status of the events log
Sequence :
get logging press Enter
The system responds :
Logging has been :[enabled/disabled.]
View log entries
This command lists all events entries in the log since the log was
enabled, or after it was last cleared. Ctrl-c aborts the listing.
Sequence :
get log entries press Enter
The system responds :
Start of log ...
0 10/07/2005 11:31:36 0 225017 477 W Demodulator lost synchronization
0 10/07/2005 11:31:36 0 225016 476 W Link is down
0 10/07/2005 11:31:36 0 225015 475 I cold start
0 10/07/2005 11:31:36 0 225014 474 W auto negotiation duplex mismatch
0 01/01/1970 00:00:11 0 225013 473 I Initialized Radio Manager
0 01/01/1970 00:00:02 0 225012 472 I Flash Log is initialized
<<<<Press any key to continue.........>>>>
End of log.
Configure events logging
This command enables and disables events logging
Sequence :
set logging [on/off] press Enter
The system responds :
Logging is :[on/off]