Product Manual

85 Appendix C – Command Line Interface (CLI)
85
Command Steps
get auto negotiation Displays the 100BaseT interface auto-negotiation parameters.
Sequence:
get auto negotiation press Enter
If the auto-negotiation is disabled, the system responds
Auto-negotiation disabled. Defaulting to 100BASE-T Full
duplex
If auto-negotiation is enabled and auto-negotiation has not failed, the
system responds:
Auto-negotiation enabled, 100BASE-T Full duplex.
If auto-negotiation is enabled and auto-negotiation has failed, the
system responds:
Auto-negotiation enabled, failed. System operating at
100BASE-T [Full|Half] duplex.
Note: The [Full|Half] indicator will be either Full or Half, based on the
negotiated link results.
get authenticated peer Unique Mode:
Displays the serial number of the system that this AirPair is
communicating with only if authentication occurs.
Group Mode
Displays the group Authentication Key of the system that this
AirPair is communicating with only if authentication occurs.
Sequence:
get authenticated peer press Enter
The system responds:
Detected peerAuthenticationKey: [see text above]
Version 2.0