Product Manual

84 DragonWave
Command Steps
get air interface
authentication type
Displays the authentication type used on the air interface.
Sequence:
get air interface authentication type press Enter
where
authentication type is one of the following:
none
unique
group
The system responds:
air interface authentication type set to [authentication type]
get airpair type Displays the type of AirPair that the system is, either an AirPair 50
or AirPair 100.
Sequence:
get airpair type press Enter
The system responds:
Your system is an [AirPair50 | AirPair100]
get antenna diameter
Displays the programmed antenna diameter.
Sequence:
get antenna diameter press Enter
The system responds:
Antenna Diameter:
12 inch
24 inch
36 inch - Programmed
Note: The antenna diameter affects the radio Tx power for radio band
un24 only.
AirPair 100 UL 24 GHz Product Manual