Product Manual

54 DragonWave Inc.
Required Action Steps
Sequence:
get snmp trap hosts press Enter
The system responds:
Host# IpAddress Status CommunityString
1 0.0.0.0 disabled public
2 0.0.0.0 disabled public
3 0.0.0.0 disabled public
4 0.0.0.0 disabled public
5 0.0.0.0 disabled public
Note: A maximum of 5 hosts is allowed. If all the hosts are filled in,
remove 1 host by overwriting the particular index.
set snmp trap host [host #]
[ipAddress] [enable/disable]
[communityString]
Adds an SNMP trap host to the list of receivers of SNMP traps. Specify
the IP address where the system sends traps.
Sequence:
set snmp trap host [host #] [ipAddress] [enable/disable]
[communityString] press Enter
The system responds:
Host# IpAddress Status CommunityString
1 0.0.0.0 disabled public
2 0.0.0.0 disabled public
3 3.3.3.3 enabled new text string here
4 0.0.0.0 disabled public
5 0.0.0.0 disabled public
Note: A maximum of 5 hosts are allowed. If all the hosts are filled
in, remove 1 host by overwriting the particular index.
get snmp traps Displays the list of traps that are available in the system.
Sequence:
get snmp traps press Enter
The system responds:
Trap# TrapName Enabled(Yes | No)
1 ColdStart No
2 WarmStart No
3 Link down No
4 Link up No
5 Explicit Authentication Failure No
AirPair 100 UL 24 GHz Product Manual