Product Manual

50 DragonWave Inc.
Procedure 6-7
Perform a data test
Perform this procedure to confirm the network link is working properly. It is assumed that you
are using an Ethernet traffic-generating device.
Connect the device to the Ethernet cable at either end.
Confirm data can be passed within desired error rates. This will ensure the network link
is working in a satisfactory manner prior to running applications over the link.
6.5.2. Connect to the LAN
This section describes how to connect the system to the LAN with an Ethernet cable.
Caution
The Ethernet Cable is meant to be connected to a Server and
therefore the signal pairs on the cable must be switched in
order to connect to a router or a switch.
Once alignment, sealing of cables and data test have been completed, connect the Ethernet
cable to your network device.
Ensure optimum throughput. The Ethernet connection to the modem is intended to operate at
100 Mbps Full Duplex for AirPair 100 and at 50 Mbps Full Duplex for AirPair 50.
AirPair 100 UL 24 GHz Product Manual