Product Manual

32 DragonWave Inc.
Required Action Steps
where
XXXX is the two byte tag control
The system responds:
VLAN tagging is [off | on using 8100XXXX]
get vlan tag Displays that the VLAN tagging information for the system is correct. If
you have entered an incorrect VLAN tag, you cannot communicate
remotely with the AirPair.
Sequence:
get vlan tag press Enter
The system responds:
VLAN tagging is [off | on using tag 8100XXXX]
save mib Saves the MIB to FLASH. Perform this command to save setting
changes to FLASH. This command does not restart the system and
does not put any new settings into effect.
Sequence:
save mib press Enter
The system responds:
Mib saved successfully.
reset system Resets the system with the new settings taking effect.
Sequence:
reset system press Enter
The system responds:
system reset.
L
Important Information about New Settings.
For the new settings to be retained it is important to
execute the “save mib” command, prior to a “reset”
command or a system power cycle. For new settings to
take effect a system reset command must be issued.
This will require a maintenance window of approximately
90 seconds.
AirPair 100 UL 24 GHz Product Manual