Product Manual

Description
25
Required Action Steps
set transmit power [power
in dBm]
Sets the transmit power level for the system, if required. Setting the
antenna diameter programs the power to the maximum level allowed.
Power will only be set to a maximum of +3, -2, or -5dBm based on the
selected antennas size of either 12”, 24” or 36” respectively.
Sequence:
set transmit power [power in dBm] press Enter
where
[power in dBm] is a multiple of 10 value, i.e. 132 represents 13.2
dBm, 94 represents 9.4 dBm.
The system responds:
System is programmed and transmitting at [powerLevel] dBm.
If the radio is not connected, the system responds:
System programmed to [powerLevel] dBm. Radio communication
has failed. System not transmitting.
If the radio transmit calibration table is not programmed into the
radio, the system responds:
System programmed to [powerLevel] dBm.
Note: Radio requires calibration tables in order to set the transmit power
level. [powerLevel] dBm will NOT be used.
save mib Saves the MIB to FLASH. Perform this command to save setting
changes to FLASH. This command does not restart the system and does
not put any new settings into effect.
Sequence:
save mib press Enter
The system responds:
Mib saved successfully.
Version 2.0