Product Manual

6 DragonWave Inc.
2.1.4. Electrocution Hazard
Warning
Electrocution Hazard
This product is intended to be connected to a –48v dc power source (supplied by DragonWave
Inc.), which must be electrically isolated from any ac sources and reliably connected to Earth
ground. Do not install DragonWave products near any type of power line. Should your antenna
or related hardware come in contact with power lines, severe bodily harm or death could
result!
2.2. Regulatory Compliance Information
This section contains information regarding regulatory compliance with the Federal
Communication Commission, Department of Communications and the European
Telecommunications Standards Institute applies to the DragonWave AirPair
TM
Radio Link.
2.2.1. Federal Communication Commission Declaration of Conformity
Statement
This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and can
radiate radio-frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures.
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
AirPair 100 UL 24 GHz Product Manual