Product Manual

118 DragonWave
Command Steps
set subnet mask
[123.123.123.123]
Sets the subnet mask used for the system.
Sequence:
set subnet mask [123.123.123.123] press Enter
The system responds:
System subnet mask: 123.123.123.123
where
[123.123.123.123] is in decimal dot notation.
set vlan tagging [on/off] Sets VLAN tagging for the system.
Sequence:
set vlan tagging [on/off] press Enter
The system responds:
VLAN tagging: [off /on]
set vlan tag [XXXX] Enables or disables VLAN tagging for the system. VLAN tagging
is enabled when you enter the 2-byte tag control information field.
Note: If you set the VLAN tag to the incorrect value, you can lose
remote access to the AirPair. Make sure the VLAN tag matches
your administrative network tag.
Sequence:
set vlan tag [XXXX] [Y]press Enter
where
[XXXX] is the two–byte tag control
[Y] is the priority bit for 802.1P and is in the range of 0-7.
The system responds:
VLAN tag: [XXXX Y]
AirPair 100 UL 24 GHz Product Manual