Product Manual

116 DragonWave
Command Steps
set snmp trap host [host
#] [ipAddress]
[enable/disable]
[communityString]
Adds an SNMP trap host to the list of receivers of SNMP traps. The
default community string is ‘public’. The default status is disable.
Sequence:
set snmp trap host [host #] [ipAddress] [enable/disable]
[communityString] press Enter
The system responds:
Host# IpAddress Status CommunityString
1 0.0.0.0 disabled public
2 0.0.0.0 disabled public
3 3.3.3.3 enabled new text string here
4 0.0.0.0 disabled public
5 0.0.0.0 disabled public
Note Only maximum of 5 hosts are allowed. If all the hosts are filled
in, remove 1 host by overwriting the particular index.
set transmit power
[power in dbm]
Sets the transmit power level for the system, if required. Setting the
antenna diameter programs the power to the maximum level allowed.
Power will only be set to a maximum of +3, -2, or -5dBm based on the
selected antennas size of either 12”, 24” or 36” respectively
Sequence:
set transmit power [power in dbm] press Enter
where
[power in dbm] is a multiple of 10 value i.e. 132 represents
13.2dBm, 94 represents 9.4dBm.
The system responds:
System is programmed and transmitting at [powerLevel] dBm.
If the radio is not connected, the system responds:
System programmed to [powerLevel] dBm. Radio
communication has failed.
System not transmitting.
If the radio transmit calibration table is not programmed into the
radio, the system responds:
System programmed to [powerLevel] dBm.
Radio requires calibration tables in order to set the transmit
power level. [powerLevel]
dBm will NOT be used.
AirPair 100 UL 24 GHz Product Manual