Product Manual

113 Appendix C – Command Line Interface (CLI)
113
Command Steps
set telnet [on/off] Enables or disables Telnet access to the system. It can only be
set via the local RS-232 interface. The default is disabled.
Available through the serial port only.
Warning: Disabling Telnet access prevents remote access to
AirPair via telnet.
Sequence:
set telnet [on/off] press Enter
The system responds:
Telnet access is [enabled | disable].
set snmp access mode
[v1/v2c/off]
Specifies whether SNMP v1 and v2c requests are enabled. The
default is ‘off’
Sequence:
set snmp access mode [v1/v2c/off]press Enter
The system responds:
SNMP Mode: [v1 | v2c | off]
Version 2.0