Product Manual

112 DragonWave
Command Steps
set radio transmitter
state [enabled/disabled]
Enables or disables the radio transmitter for testing purposes.
Sequence:
set radio transmitter state [enabled/disabled] press Enter
The system responds:
radio transmitter :[enabled/disabled]
set radio band [none /
un24]
Sets the band of radio to which the user expects to connect the modem.
Sequence:
set radio band [band] press Enter
where
band is none / un24
The system responds:
Radio band Selected [none/un24].
set radio rxgain Sets the radio receive (Rx) gain.
Note: The Rx Power is preset at the factory. Do NOT change this
setting unless explicitly instructed to do so by DragonWave
Support.
Sequence:
set radio rxgain [gain] press Enter
where
[gain] is a value 20 and 40.
The system responds:
Radio rx gain set to [gain]
set traffic statistics [0] Resets all traffic statistics to 0. The only parameter accepted is ‘0’.
Sequence:
set traffic statistics [0] press Enter
The system responds:
Traffic statistics cleared.
AirPair 100 UL 24 GHz Product Manual