Product Manual

111 Appendix C – Command Line Interface (CLI)
111
Command Steps
set group authentication
key [key]
Sets the group authentication key.
Sequence:
set group authentication key [key] press Enter
where
[key] is a eight character string.
The system responds:
group key authentication set to [key]
set network protocol
strict [on/off]
Sets the network access to the AirPair system to either force the
access through a management VLAN (strict is on) or to allow
access from devices on the network without use of a management
VLAN (strict is off)
The default state is inband.
Sequence:
set network protocol strict [on/off] press Enter
The system responds:
Network protocol strict is: [on/off]
set programmed
frequency [Frequency
Index (as specified in
‘get available frequency’
command)]
Sets the frequency of the TX IF and RF stage.
Sequence:
set programmed frequency [Frequency Index] press Enter
where
[frequency index] must be an enabled frequency
The system responds:
Index TX IF RX IF TX RF RX RF
UNL1 670 1610 20480 24150
All Frequency in MHz
Notes:
1. Set the programmed frequency after you issue the reset
system command.
Version 2.0