Product Manual

109 Appendix C – Command Line Interface (CLI)
109
Command Steps
set airpair type Sets the AirPair type to 50 or 100. If you have an AirPair 100, you
can set your AirPair to 50. If you have an AirPair 50 and you want
to set it to an AirPair 100, contact DragonWave Technical
Support.
Note: If you perform this command remotely, do the far end first,
then do the other end. Perform the reset command only after both
AirPair units have been set to the correct type.
Sequence:
set airpair type [airpair 50/airpair100] press Enter
The system responds:
Your system is set to :[airpair 50/airpair100].
set antenna diameter
[index]
Displays the programmed antenna size.
Sequence:
Set antenna diameter [index] press Enter
where
index is 1,2,3
The system responds:
Programmed Antenna Diameter: [12 inch /24 inch /36 inch]
Note: The antenna diameter affects the radio Tx power for radio band
un24 only.
set auto negotiation
[on/off]
Sets the 100BaseT interface auto-negotiation parameters. Set
Auto-negotiation Off to force link to 100 Mb/s Full Duplex.
Sequence:
set auto negotiation [on/off]press Enter
The system responds:
auto negotiation [on | off]
Version 2.0