Product Manual

93 Appendix C – Command Line Interface (CLI)
93
Command Steps
get leds Displays the system LEDS with their ON/OFF values.
Sequence:
get leds press Enter
The system responds:
Ethernet Link Status LED : [on | off]
Ethernet Traffic LED : [on | off]
Ethernet Full Duplex Mode LED : [on | off]
System Trouble LED : [on | off]
Power LED : [on | off]
modem Sync LED : [on | off]
RF On LED : [on | off]
Antenna Alignment : [0 – 100] %
get modem card
modulation
Displays the modem modulation type.
Sequence:
get modem card modulation press Enter
The system responds:
modem modulation type [modulation type]
Note: [modulation type] is one of the following:
QPSK
QAM
QAM16
QAM32
QAM64
QAM128
QAM256
Version 2.0