User's Manual

Setting Up SNMP

Version 1.0

Required Action Steps

Sequence:

set snmp trap [trapIndex] [enable/disable] press Enter

The system responds:

Trap# TrapName Enabled(Yes | No)

1 ColdStart No

2 WarmStart No

3 Link down No

4 Link up No

5 Explicit Authentication Failure No

6 AutoNeg Mismatched Duplex No

7 LossOfSignalLockFromDemod No

8 BerThresholdExceeded No

9 Mod PLL lock failure No

10 Mod loss of sync bytes No

11 Mod input FIFO overrun/underrun No

12 Mod input data inactivity No

13 SNR below threshold No

14 PLDRO lost lock No

15 Radio lost comm No

16 Radio mismatch No

17 IF Tx Synth Unlocked No

18 IF Rx Synth Unlocked No

reset system Resets the system to save the settings to FLASH and restarts the

system with the new settings taking effect. If you do not wish to restart

the system, use the command save MIB to save the settings to

FLASH.

Sequence:

Reset system press Enter

The system responds:

System reset.