User's Manual

DragonWave Inc. 56
AirPair 100 UL 24 GHz Product Manual
Required Action Steps
1 192.168.1.133 example text1
2 192.168.1.100 example text2
If there are no managers specified, the system responds:
No managers configured for the system.
set snmp manager [mgr#] [ip
address] [enable/disable]
[community string]
Specifies the SNMP managers to allow access to the system.
Sequence:
set snmp manager [mgr#] [ip address] [enable/disable]
[community string] press Enter
The system responds:
Mgr# IpAddress Status CommunityString
1 192.7.1.1 disabled public
2 0.0.0.0 disabled public
3 0.0.0.0 disabled public
4 0.0.0.0 disabled public
5 0.0.0.0 disabled public
6 any disabled public
Note 1: Only maximum of 5 managers are allowed. If all the
managers are filled in, remove 1 manager by overwriting the
particular index.
Note 2: By setting the IP address of last index to 'any' and
'enable', anybody can have access to the system via SNMP.
set SysContact Sets System contact to allow access MIB objects via an SNMP
browser. For example, you can set the sysContact in MIB-II (RFC
1213) using your MIB browser, e.g., HP OpenView Node Manager.
save mib Saves the MIB to FLASH. Perform this command save setting
changes to FLASH. This command does not restart the system and
does not put any new settings into effect.
Sequence:
save mib press Enter
The system responds:
Mib saved successfully.