User's Manual

Installation of Radio and Antenna
53
Version 1.0
6.5.1. Perform a Data Test
This section describes how to perform a data test.
Procedure 6-7
Perform a data test
Perform this procedure to confirm the network link is working properly. It is
assumed that you are using an Ethernet traffic-generating device.
1. Connect the device to the Ethernet cable at either end.
2. Confirm data can be passed within desired error rates. This will ensure the
network link is working in a satisfactory manner prior to running applications
over the link.
6.5.2. Connect to the LAN
This section describes how to connect the system to the LAN with an Ethernet
cable.
Caution
The Ethernet Cable is meant to be connected to a Server and
therefore the signal pairs on the cable must be switched in
order to connect to a router or a switch.
Once alignment, sealing of cables and data test have been completed, connect
the Ethernet cable to your network device.
Ensure optimum throughput. The Ethernet connection to the modem is intended
to operate at 100 Mbps Full Duplex for AirPair 100 and at 50 Mbps Full Duplex
for AirPair 50.