User's Manual

Installation of Radio and Antenna
45
Version 1.0
Procedure 6-5
Connect the power cable to the modem and the power pack
Caution
Install the Power cable only after proper grounding and
lightning protection has been established.
Caution
Connect the Airpair system to an Uninterruptable Power
Supply (UPS) or equivalent system in order to withstand
power outages.
Caution
Cables must have strain-relief support. Ensure cabling is
attached to tower or mast in a manner to provide maximum
strain relief.
Figure 6-6
6-LED Panel on Modem
Perform this procedure to connect the power cable between the modem and the
power pack.
1. Connect cable between modem and power pack.
2. Plug the power pack into the ac outlet.
3. Ensure the modem is receiving electrical power by viewing the Power LED on
the modem.
4. Ensure radio is receiving power. The RF On LED is lit on the modem.
5. Do NOT connect the CAT5 Ethernet cable to LAN equipment at this time.
Caution
Do NOT connect the CAT5 Ethernet cable to LAN equipment
at this time.