User's Manual

Description
33
Version 1.0
Procedure 4-6
Setting VLAN Tag
i
Note
If you set the VLAN tag to the incorrect value, you can lose
remote access to the AirPair. Make sure the VLAN tag matches
your administrative network tag.
Perform this procedure to enable VLAN tagging for the AirPair.
Note: To perform this procedure, you must have NOC user rights.
Required Action Steps
login Log in as an NOC user.
Sequence:
Enter an NOC username:
username: <username> press Enter
Enter an NOC password:
password: <password> press Enter
get vlan tagging Displays the VLAN tagging operational state for the system.
Sequence:
get vlan tagging press Enter
The system responds:
VLAN tagging is [off | on]
set vlan tagging [on/off] Sets VLAN tagging on for the system.
Sequence:
set vlan tagging on press Enter
The system responds:
VLAN tagging is on.
set vlan tag [8100XXXX] Enables or disables VLAN tagging for the system. VLAN tagging is
enabled when you enter the hex characters 8100 immediately followed
by the 2-byte tag control information field. Note: If you set the VLAN
tag to the incorrect value, you can lose remote access to the
AirPair. Make sure the VLAN tag matches your administrative
network tag.
Sequence: